Most people think that we need to spend a lot of money on sound deadening a car. However, what we do not know is that we can do a DIY once you have your soundproofing materials. You might think that it is difficult and complicated. However, there is a simpler and easy way of how you can sound deadening a car without spending a huge sum on the professional fees.

Down below are the quick easy steps that you can do in sound deadening a car:

Get a tape measure and start measuring.

The first thing that you have to do is measure the parts that you need to soundproof. Dampening sheets or Sound Dampening foams aren't pre-cut. Although some companies have a pre-cut foam, it is still best to measure them. With your tape measure, start measuring from the roof, doors, trunk, engines, and floor

Install the foams on the roof and doors

Get a screwdriver and remove the panels of your roof and doors. Grab your adhesive and start installing the foams on the roof and doors. Let the adhesive dry out for a bit before putting back the panels. Once the adhesive is dry, screw back the panels. To learn more about sound deadening a car, visit on hyperlinked site.

Remove the car seats before installing the floor mats

Before soundproofing your floor, make sure they remove the seats of your car. it would be difficult to sound deadening a car when the seats are still present. Make sure to remove them before installing the sound dampening floor mats. Remove the old floor mat and clean the car floor before installing them. The old dirt can affect the adhesion of the floor mat, make sure that they are cleaned off. When installing the floor mat, grab a paint roller and smoothen them out.

Proceed to install the mat in the trunk. The installation of sound dampening foams into the trunk is pretty similar to the car floor. You can use the same procedure for it. After installing the mat inside the trunk, make sure to wrap the butyl foils on the wheel well. These foils will help lessen the rambling sounds and vibrations in the trunk

Soundproof Engine

Soundproofing your engine roof is pretty easy. You just install the foam and you are done. However, for the engine, make sure that you are using a heat resistant foam. Engines can get hot, adding a foam that isn’t heat resistant can cause a fire. If your sound deadening foam isn’t heat resistant make sure that you buy a separate one instead.

Conclusion

Sound deadening a car is pretty easy. With all the materials needed, you can easily soundproof your car on your own. So why spend money on soundproofing your can when you can DIY it? Can when you can DIY it?